Cordless drill driver

DeWalt DCD794NT-XJ 18V XR Brushless Compact Drill Driver, 74 Nm, Bare Tool

A 175 mm body that fits inside cabinets, between joists and overhead.

The DeWalt DCD794NT-XJ is a compact 18V XR brushless drill driver built for professional drilling and fastening. It ships as a bare tool in a TSTAK case, a natural add-on if you already run DeWalt 18V batteries.

Brushless motor with 74 Nm of torque

The 2-speed gearbox gives you 0–450 rpm for driving long screws and 0–1650 rpm for fast drilling. Soft-joint torque is rated at 26 Nm. With no brushes to wear out, the motor needs less maintenance than a brushed design.

Drills up to 30 mm in wood and 13 mm in steel

The keyless 13 mm metal chuck lets you swap bits one-handed. Fifteen clutch settings cap the torque while driving, so you don't strip screw heads or sink fasteners too deep into soft material.

Compact housing with LED work light and belt hook

At 1.12 kg without a battery, it stays manageable overhead and through long fastening runs. The built-in LED light picks out the work spot inside cabinets and corners. When you're up a ladder, the belt hook keeps the drill within reach.

Bare tool for the DeWalt 18V XR system

The drill takes DeWalt 18V XR and XR FLEXVOLT batteries of any Ah rating. The TSTAK case locks onto other boxes in the system, so you can carry the drill and its accessories as one stack.